5" Galvalume Round Elbows

Printer Friendly Version

The average downspout installation requires 2 elbows at the top and 1 at the bottom. If you are connecting your downspout into a drain tile, the elbow at the bottom is not necessary.

The offset is the measurement of 2 connected elbows. See the offset column below to determine the correct elbow selection. For offsets greater than 11" extra downspout will be needed.

An overhang of less than 5" will require 2-40 degree elbow. This elbow combination also works when making a transition around a ledge of other protrusion.

You will need to reduce the size of the opening on the elbows and downspout when installing the downspout system. (See installation tips)

5" 72 degree galvalume elbows

5" 40 degree galvalume elbows

5" X 24 GAUGE GALVALUME ROUND ELBOWS

Item#	Description	Offset	Price (each)

EL5GAL4S	5" x 40° smooth	5"-10"	$7.75
EL5GAL7S	5" x 72° smooth	11"	$7.75

EL5GAL4CR	5" x 40° corrugated	5"-10"	$7.75
EL5GAL7CR	5" x 72° corrugated	11"	$7.75

Installation tips:

A downspout & elbow crimper tool will reduce the size of the opening by crimping the edges of the smooth downspout and elbows.

A needle nose pliers may be used to reduce the size of the opening when connecting corrugated elbows and downspout. Take hold of the inside corrugation with the pliers and turn so the corrugation becomes tighter.

Please click for downspout and elbow crimper details